Juniper Networks G10 CMTS manual Remove a Chassis Control Module, User@host request system halt

Module Removal

Figure 48: HFC Connector Module Removal

2

	1			DS		0
	U	S	0	D	S	1
	U	S	1	DS		2
	US		2	D	S	3
3
	US		3
		Eth		0
		Eth		1

1

2

Remove a Chassis Control Module

The Chassis Control Module is hot-swappable. However, if you hot-swap the Chassis Control Module, all services supported by the CMTS are lost because the CMTS cannot operate without the Chassis Control Module.

To remove a Chassis Control Module, follow this procedure:

1.Stop the CMTS software by issuing the request system halt command:

user@host> request system halt

2.Power down the CMTS.

3.Follow the same procedure described in “Remove a DOCSIS Module” on page 166.

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

Replacement Procedures 169