Juniper Networks G10 CMTS manual Remove a Hard Disk Module, Remove a NIC Module, 170

Module Removal

•Remove a Hard Disk Module

•
•	To remove a Hard Disk Module, follow this procedure:
•
•	1.	Stop the CMTS software by issuing the request system halt command:
•
•		user@host> request system halt
•
•	2.	Power down the CMTS.
•
•	3.	Follow the same procedure described in “Remove an HFC Connector Module or SIM” on
•		page 168.
•
•

•Remove a NIC Module

•
•	The NIC Module is hot-swappable, so you can remove it or install it while the CMTS is
•	powered on. To remove a NIC Module, follow the same procedure described in “Remove a
•	DOCSIS Module” on page 166.
•
•

•Remove a NIC Access Module

•
•	The NIC Access Module is hot-swappable, so you can remove it or install it while the CMTS is
•
	powered on. To remove a NIC Access Module, follow the same procedure described in
•
	“Remove an HFC Connector Module or SIM” on page 168.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

170 JUNOSg 3.0 G10 CMTS Hardware Guide