Juniper Networks G10 CMTS manual 113, Cable a Chassis Control Module

Cable a Chassis Control Module

Cable a Chassis Control Module			•
			•
The Chassis Control Module contains a Fast Ethernet RJ-45 port labeled Eth0 on its front			•
panel (see Figure 15 on page 39). This port is used for the management interface to the			•
CMTS.			•
			•
To connect to the Chassis Control Module management port, follow this procedure:			•
			•
1. Carefully thread the Ethernet cable into the cable channel from the rear of the chassis			•
	(see Figure 6 on page 13) until it extends through the opening of the power supply		•
	faceplate.		•
			•
2. Plug the RJ-45 connector of the Ethernet cable into the RJ-45 port of the Chassis Control			•
	Module labeled Eth0.		•
			•
3.	Attach the other end of the Ethernet cable to its network equipment in the headend.		•
			•
			•
Cable a NIC Module			•
			•
The NIC Module contains two full-duplex, Gigabit Ethernet GBIC transceiver ports on its front			•
			•
panel. See “NIC Module” on page 42 for the specifications of the various types of GBIC
			•
interfaces provided.
			•
To connect the network cables to the Gigabit Ethernet ports, follow this procedure (see			•
			•
Figure 16 on page 43 for port labeling):
			•
1.	Carefully thread each of the two cables into the cable channel from the rear of the		•
			•
	chassis (see Figure 6 on page 13) until they extend through the opening of the power
			•
	supply faceplate.
			•
2.	Connect the transmit/receive pair of each of these cables to the GBIC ports labeled 0		•
			•
	and 1 on the NIC Module.
			•
3.	Attach the other end of each cable to its network equipment in the headend.		•
			•
			•
			•
		If using optical cables, avoid bending the cables too	•
		sharply when threading them through the cable channel.	•
			•
			•
			•
Figure 36 on page 114 provides the front view of the chassis with the network cables installed			•
			•
into a NIC Module.
			•
			•
			•
			•
			•
			•
			•
			•
			•
			•
			•
			•
			•

Install the CMTS 113