Juniper Networks G10 CMTS manual JUNOSg 3.0 G10 Cmts Hardware Guide

Notices

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•Notices

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

!All modules and power supplies are designed to smoothly slide into the G10 CMTS chassis using the card guides. Do not apply excessive force during the insertion of any assembly into the system. If resistance to insertion is encountered while installing any assembly, carefully remove it, realign its card edge with the chassis’ card guides, and reinsert it into the system.

!When you install a rear chassis module, apply more pressure to the upper ejector than to the lower ejector. This ensures the module connectors on the top of the card edge are properly aligned with the midplane connectors. The bottom edge has no connectors, so you do not need to press the rear ejector as firmly.

!Do not operate the G10 CMTS without the front and rear fan trays that are shipped with the system.

!Do not apply torque to screws that is below or above the specifications provided herein.

!This equipment is intended only for installation in a restricted access location within a building.

!This equipment is intended for indoor use only.

!This equipment does not have a direct copper connection to the outside plant.

!Removal of power supplies or cards will result in access to hazardous energy.

!Each power cord must be connected to an independent branch circuit.

!Product connected to two power sources. Disconnect both power sources before servicing.

Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

70 JUNOSg 3.0 G10 CMTS Hardware Guide