Juniper Networks G10 CMTS manual G10 Cmts Installation Checklist

G10 CMTS Installation Checklist

•G10 CMTS Installation Checklist

•
•	Table 38 summarizes all the steps outlined in this document that are required to successfully
•	install the G10 CMTS in the headend. We recommend that copies of this table be made and
•	used to keep track of the installation status of each G10 CMTS.
•
•
•	Table 38: G10 CMTS Installation Checklist
•
•
	Step	Page Number	Completion Status
•
	Preparation for Installation
•
•	Complete all checklists in “Prepare the Site”	page 67
•
	Completely review the G10 CMTS Hardware Guide, including the safety precautions	—
•
	Verify the contents of the shipping cartons	page 89
•
	Verify the number of pre-installed modules and power supplies in the chassis is correct
•
•	Verify the contents of all accessory kits
•
	Install the power supply faceplate and the air intake faceplate
•
	Ground and Rack Mount the Chassis
•
•	Crimp the supplied two-ring lug connector to the earth ground strap	page 94
•	Attach the earth ground strap to the chassis
•
	Ensure proper ventilation clearance surrounding the G10 CMTS	page 94
•
	Install an equipment shelf in the rack
•
•	If applicable, install the rack mounting brackets
•
	Slide the chassis onto the shelf and mount it to the rack
•
	Attach the earth ground strap to earth ground
•
	Install Power Supplies
•
•	Remove the power supply faceplate	page 101
•
	Determine the bay in which to install the power supply
•
	Remove the power supply filler panel
•
•	Release the ejector, align to the card guides, insert the power supply, and close the
•	ejector
•	Tighten the self-contained screws
•
	Replace the power supply faceplate
•
	Install a DOCSIS Module and an HFC Connector Module or SIM
•
	Remove the air management module where the DOCSIS Module will be inserted	page 103
•
•	Release the ejectors, align to the card guides, insert the DOCSIS Module, and close the
•	ejectors
•	Tighten the self-contained screws
•
	Remove the air management panel where the HFC Connector Module or SIM will be
•
	inserted
•
	Release the ejectors, align to the card guides, insert the HFC Connector Module or SIM,
•
	and close the ejectors
•
	Tighten the self-contained screws
•
•
•
•
•
•
•
•

90 JUNOSg 3.0 G10 CMTS Hardware Guide