Juniper Networks G10 CMTS manual Step Number Completion Status

G10 CMTS Installation Checklist

Step	Page Number	Completion Status	•
			•
Install a Chassis Control Module and a Hard Disk Module
			•
Remove the air management module where the Chassis Control Module will be inserted	page 108		•
			•
Release the ejectors, align to the card guides, insert the Chassis Control Module, and
close the ejectors			•
			•
Tighten the self-contained screws
			•
Remove the air management panel where the Hard Disk Module will be inserted
			•
Release the ejectors, align to the card guides, insert the Hard Disk Module, and close the			•
ejectors			•
Tighten the self-contained screws			•
			•
Install a NIC Module and a NIC Access Module
			•
Remove the air management module where the NIC Module will be inserted	page 108
			•
Release the ejectors, align to the card guides, insert the NIC Module, and close the
			•
ejectors			•
Tighten the self-contained screws			•
Remove the air management panel where the NIC Access Module will be inserted			•
			•
Release the ejectors, align to the card guides, insert the NIC Access Module, and close
			•
the ejectors
			•
Tighten the self-contained screws
			•
Cable an HFC Connector Module or SIM
			•
Determine how the cable plant nodes will be connected to the downstream and	page 109		•
upstream ports of the module			•
Connect each of the four downstream ports to its respective node			•
			•
Connect each of the four upstream ports to its respective node
			•
Dress all cables appropriately
			•
Cable a Chassis Control Module			•
Thread the Ethernet cable through the cable channel from the rear of the chassis	page 113		•
			•
Connect the RJ-45 connector of the Ethernet cable to the Eth0 port on the Chassis
			•
Control Module
			•
Connect the other end of the Ethernet cable to its respective network equipment in the
			•
headend
			•
Cable a NIC Module and a NIC Access Module (if applicable)
			•
Thread the network cables through the cable channel from the rear of the chassis	page 113		•
			•
Connect each of the two Gigabit Ethernet network cables to the ports on the NIC
Module			•
			•
Connect the other ends of the network cables to their respective network equipment in
			•
the headend
			•
Connect the RJ-21 end of the NIC Access Module cable into the NIC Access Module and
			•
tighten the cable retainer screws
			•
Connect eight RJ-45 connectors of the NIC Access Module cable to a maximum of four
			•
HFC Connector Module
			•
Dress all cables appropriately
			•
Attach a PC to the Chassis Control Module			•
Connect the serial cable to the COM port on the Chassis Control Module	page 119		•
			•
Connect the other end of the serial cable to the serial port on the PC
			•
			•
			•
			•
			•
			•

Prepare the Site 91