Cisco Systems WSC3560CG8PCSRF manual Running Express Setup

Catalyst 3560-C and 2960-C Switch Getting Started Guide

Running Express Setup

You should use Express Setup to enter the initial IP information. You can then access the switch through the IP address for further configuration.

Note To use the CLI-based initial setup program, see Appendix C, “Configuring the Switch with the CLI Setup Program,” in the switch hardware guide.

You need this equipment:

•PC with Windows 2000, XP, Vista, or Windows Server 2003

•Web browser (Internet Explorer 6.0, 7.0, or Firefox 1.5, 2.0, or later) with JavaScript enabled

•Straight-through or crossover Category 5 or 6 cable

Note Before running Express Setup, disable any pop-up blockers or proxy settings on your browser and any wireless client running on your PC.

.

Step 1 Make sure that nothing is connected to the switch.

During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address, temporarily configure your PC settings to use DHCP before going to the next step.

Note Write down the static IP address. You will need this IP address in Step 10.

Step 2 Power the switch:

For switch models with an AC power connector

•Plug the AC power cord into the AC power connector and into an AC power outlet. For switch models with an AUX power connector

•Connect a 10/100/1000 uplink port to a PoE switch, such as a Catalyst 3750-X. Or

•Plug the auxiliary power adapter cord into the AUX power connector and into an AC power outlet.

Note For more information on powering the switches, see the “Switch Installation” chapter in the hardware guide.

Catalyst 3560-C and 2960-C Switch Getting Started Guide

4 OL-23802-02