Citizen CBM1000II Location of DIP Switches, Table for Setting DIP Switches, DIP switch

ENGLISH

4.SETTING DIP SWITCHES

4.1Location of DIP Switches

1Turn off the power of the printer.

2Open the printer cover.

3Remove the paper roll and the DIP switch cover.

4After completing the setting, place the cover to the original position.

CAUTION

•Do not make settings while the printer is turned on.

DIP switch cover

*DIP switch 3 is only for the serial interface.

4.2Table for Setting DIP Switches

4.2.1DIP switch 1

No.	Function		ON	OFF	Factory presetting
1-1	Auto cutter		Available	Not available	ON
1-2	Unused		-	-	OFF
1-3	Paper width		58 mm	80 mm	OFF
1-4	Print columns*		42 columns (80 mm)	48 columns (80 mm)	OFF
			30 columns (58 mm)	36 columns (58 mm)
1-5	CR mode		LF operation	Ignored	OFF
1-6	Input buffer		72 bytes	4K bytes	OFF
1-7		Print density (See the tabel below.)			ON
1-8					OFF

* It will be different according to the setting of paper width (DS1 – 3).

Print density

Print density	Level 1	Level 2	Level 3	Level 4
No.	(Light)	(Standard)	(Slightly dark)	(Dark)
1-7	OFF	ON	OFF	ON
1-8	OFF	OFF	ON	ON

Note: If print density is set to level 2 (Standard) or over, print speed may decrease.

— 22 —