Citizen CBM1000II Connecting the Drawer Kick-Out Connector, Turn off the power of the printer

3.3 Connecting the Drawer Kick-Out Connector

1	Turn off the power of the printer.	Drawer kick-out connector
2	Orient the drawer kick-out cable connector
	correctly, insert it into the drawer kick-out
	connector on the back of the printer.
3	Fasten the ground wire to the ground
	connector on the printer with a screw.

ENGLISH

Ground wire

Drawer kick-out cable connector

CAUTION

•Do not connect any other device than the specified drawer (Solenoid) to the drawer kick-out connector. (Do not connect a telephone line either.)

(1) Connector Pin Configuration

No.	Signal	Function
1	FG	Frame Ground

2DRAWER 1 Drawer 1 drive signal

3DRSW Drawer switch input

4	VDR	Drawer drive power supply
5	DRAWER 2	Drawer 2 drive signal
			6	1
6	GND	Common ground on circuits

Connector used: TM5RJ3-66 (Hirose) or equivalent

Applicable connector: TM3P-66P (Hirose) or equivalent

(2)Electrical characteristics

1)Driving voltage: 24 VDC

2)Driving current: Approx. 1 A max. (shall not exceed 510 ms.)

3)DRSW signal: Signal levels: “L”=0 to 0.5 V, “H”=3 to 5 V

(3)DRSW signal

DRSW signal status can be tested with the DLE+EOT, GS+a, or GS+r command or at pin 34 on the parallel interface port.

(4)Drive Circuit

1

2

3

4

5

6

CAUTION

VDR

VDR

•No output is produced while printing.

•The drawers 1 and 2 cannot be driven simultaneously.

•A solenoid used for the drawer should be of 24 Ω or more. The output current should be kept at 1 A or less; otherwise, breakdown or burning could occur.

— 15 —