8.DRAWER KICK CONNECTOR
8.1Specifications
(1)Drawer kick drive signal
The pulses specified by ESC p are output. The state of the switch(+) can be known through the pin 34 of the interface connector when parallel interface is used, and through the ESC u command when the serial interface is used.
(2)Electrical characteristics
1) | Drive voltage | : DC 24 V |
|
2) | Drive current | : 0.8 A at maximum(should be within 510 ms) | |
3) | Switch signal | : Signal level | "L" = 0 to 0.5 V |
|
|
| "H" = 3 to 5 V |
8.2Connector's Pin Configuration
No. | Signal Name | Function |
1 | FG | Frame ground |
2 | DRAWER 1 | Drawer 1 drive signal |
3 | DRSW | Drawer switch input |
4 | VDR | Drawer driving power |
5 | DRAWER 2 | Drawer 2 drive signal |
6 | GND | Common ground on the circuits |
|
|
|
Connector used | : |
Applicable connector | : Equivalent to |
[Cautions] 1) No output is allowed during printing.
2)The drawers 1 and 2 cannot be driven at the same time.
3)A solenoid for the drawer should be of 36 Ω or more.
(See to it that an output current will not exceed 0.8 A. Be careful not to use a drawer with a current over 0.8A to avoid damage to the printer.)
8.3Drive Circuit
26 | CITIZEN |
