Lincoln Electric SVM200-A service manual Swing Arm, Pin Collar Pins, Table & Swing ARM SET-UP

Return to Section TOC Return to Master TOC

A-7

INSTALLATION			A-7
4. Obtain the three post collarTM			pins from the factory
	packaging of the VRTEX 360.
		Swing Arm
	Table		Post

T Pin

Collar

Pins

Return to Section TOC Return to Master TOC

14. Insert the input supply power cord into the back of

theand into a standard electrical outletVRTEXcapableTM 360of 115 to 230 VAC at 4 to 2 Amps.

TABLE & SWING ARM SET-UP:

1. Using the 3/16” allen wrench, remove the two ¼” x 20 Allen-head screws from the base assembly.

NOTE: The longer screw is in the top.

5.Insert one of the collar pins into the post at the #6 location.

6.From the top, slide the table onto the post letting it rest on the collar pin inserted in previous step.

7.Insert the second collar pin into the post at the #13 position.

8.Obtain swing-arm from the rear of the

by removing the cable ties from the swingVRTEXarmTM and360 cable. Grey cable should remain connected to the VRTEXTM 360 (DO NOT CUT!).

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

2. Insert red post into base assembly aligning the flat on the pole with the hole.

NOTE: The post will only insert one way.

3. Using the 3/16” allen wrench, secure the post into position and tighten.

Cable Tie

Grey Cable

(DO NOT CUT)

VRTEX TM 360