OPERATION |
Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
MoveTable/Armthe physicalRotationVR table and arm to the desired location for the position and joint configuration select- ed. To raise or lower the arm or table, hold the arm/table in place and pull out the pin in the pole sup- porting it. Replace the pin in the hole that supports the arm/table at the proper height and rest the arm/table on the pin. If the table is not needed, swing the table to the left and out of the way. The arm can also be rotated to the left (A), center (B) or right (C) of the table.
SWING ARM ROTATION
POS. A | POS. C |
POS. B
WhenPin Positionsthe physical stand is in the desired position, pro- ceed with the following: Use the joystick and red select button to enter the numbers that appear next to the pin positions for the table and arm height, into the stand setup screen. The image on the right side of the stand setup screen moves to match the selections entered on the left. If the table is in the “away” position, enter a table height value of 0. Next, enter the arm rotation position A (left), B (center), C (right). The arm position letter aligns with the vertical pin number sticker. An arm height of 18 and and arm rotation of A is shown in the picture below.
PIN POSITIONS 18 A
Return to Section TOC Return to Master TOC
TABLE ROTATION
Note: If the table height indicator in the software cannot be moved to the pin height indicated on the post, move the arm height indicator in the software to a higher position and try again. See Troubleshooting Guide if neces- sary.
Return to Master TOC
Return to Section TOC
VRTEX TM 360
