OPERATION |
Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
TheStandstand is comprised of the post, arm, table, collar pins, base and two weights. Users should position themselves at the stand during virtual welding.
ThePostarm and table slide up and down and rest on the collar pins that are inserted into the post. Hole num- bers 0 through 28 indicate position of welding for pro- gram accuracy. The position is read by identifying the numbered hole that the pin has been inserted into.
POST W/PIN INSERTED IN #18
TheCouponcouponsPositionican be insertedg In Swinginto theArmarm to accom- modate flat, horizontal, vertical or overhead welding positions. The knob on the front of the swing arm can be pulled out for coupons to be inserted or removed and pushed in for coupons to be secured. The front of the swing arm can be rotated down at a 45 or 90- degree angle to allow 2G, 5G and 6G pipe welding positions. The arm can also be rotated around the post to comfortably accommodate left and right handed welders or simulate specific welding applications.
COUPON INSERTION / REMOVAL
SWING ARM ROTATION
POS. A | POS. C |
POS. B
Theabletable can be used to gain stability and learn prop- er body positioning. The base supports the stand and has weights on the back to maintain stability. The table can be swung out of the way when not in use.
CAUTION
Do not use the Stand/Table without the base counter weights properly positioned.
TABLE ROTATION
Return to Section TOC Return to Master TOC
CAUTION
Do not use excessive force when inserting and removing coupons into the arm.
VRTEX TM 360
