
Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
TROUBLESHOOTING AND REPAIR |
VR SMAW (STICK) DEVICE
REMOVAL AND REPLACEMENT PROCEDURE (continued)
FIGURE F.41 – VR SMAW DEVICE LOCATION
Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
REMOVAL PROCEDURE 1. Remove input power.
2. Perform the
. Monitor and Pedestal Removal
3. Performrocedurethe.
4. Locate the VRCaseSMAWCoverDeviceRemoval. See FigureProc dureF.41.
5. Disconnect plug J3 from the relay board. See
Figure F.22.
6. Using the 3/8” wrench, remove the two screws holding the sheet metal strain relief to the front panel.
7. Locate Seeand Fdisconnectgure F.42.the 16 pin molex style cable splice. See wiring diagram.
VRTEX TM 360