Lincoln Electric SVM200-A service manual Process Selection Screen, Stand Set-Up Screen, Overview

B-10 OPERATION B-10

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Process Selection Screen:

ThisOverviscreenw allows the user to select the welding processes. To change among VR GMAW, VR FCAW, and VR SMAW, the user moves the process switch on the front of the weld machine. See the joint configura- tion chart for available processes. If a process is not supported for the selected material/thickness, it is greyed out on this screen and cannot be selected. To choose among different sub-processes, use the joy- stick and red select button or green continue button.

At the top of the screen, the user can see the coupon position and thickness selected. As the user continues to set up the simulation, additional information will be added to the right of this readout, so that the user can reference what has previously been selected.

PROCESS SELECTION SCREEN

SelectingMenu brings the user back to the login screen, withLogoutthe userʼs name removed.

SelectingChange Coupon Type goes back to the configurationChangeselectionCouponscreenType.

SelectingBack Back takes the user to the previous screen.

Stand Set-Up Screen:

Overview

The correct VR stand information must be put into the software for the VRTEXTM to operate properly in all virtual welding applications.

STAND SET-UP SCREEN

InsertCouponone ofInsthertionVR coupons into the desired position in the physical VR stand. Make sure the coupon is seated into the track and then lock the coupon in place by pushing in the knob at the end of the arm. To release, pull the knob into the unlocked position and remove the coupon. When the system is in use, the coupon should always be locked in place to assure system accuracy.

VR COUPON (UNLOCKED POSITION)

Return to Master TOC

Return to Section TOC

VRTEX TM 360