Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
Return to Section TOC Return to Master TOC
TROUBLESHOOTING AND REPAIR | ||||||
Observe Safety Guidelines detailed in the beginning of this manual. |
|
| ||||
| PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED | |||
| (SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION | |||
|
|
|
|
| ||
The | weld coupon image is a | Either the wrong coupon is on | N/A |
| ||
|
| FUNCTION PROBLEMS |
|
| ||
different configuration than the | the stand or the wrong |
|
| |||
physical coupon. | configuration as been selected |
|
| |||
|
| in the software. |
|
|
| |
|
| Press the menu button and |
|
| ||
|
| select change coupon type. |
|
| ||
|
| Change the software selections |
|
| ||
|
| so that the images on the |
|
| ||
|
| screen match the hardware you |
|
| ||
|
| are using. |
|
|
|
|
The arm and/or table are different | The software information may | N/A |
| |||
than the visuals in the software. | be incorrect. | Press the menu |
|
| ||
|
| button and | select change |
|
| |
|
| process. Make sure the images |
|
| ||
|
| on the screen match the |
|
| ||
|
| hardware being used. |
|
| ||
When the check settings are | Check the settings in the | N/A |
| |||
activated the incorrect settings | Instructor Mode. |
|
|
| ||
appear. | Make sure all of the settings are |
|
| |||
|
| correct for the process and |
|
| ||
|
| parameters being used. Check |
|
| ||
|
| for the acceptable ranges for the |
|
| ||
|
| Lincoln defaults. |
|
|
| |
Holding the green button in does | To shut down the VRTEXTM 360 | N/A |
| |||
not shut down the VRTEXTM 360 | select menu and then select |
|
| |||
|
| shutdown. |
|
|
|
|
Sometimes the view in the helmet | Make sure the helmet is close to | Check for loose or faulty | ||||
seems to shake, wobble or jitter. | the work piece. The further the | connections on the VGA cable | ||||
|
| helmet is from the work piece | between the Relay Board and | |||
|
| the more jitter there may be in | the Polhemus Interface Module. | |||
|
| the helmet display. | Also make | See the wiring diagram. | ||
|
| sure there are not other objects | Perform the |
| ||
|
| or frequencies | that are | Polhemus | ||
|
| interfering with the system. | Interface Module Test. | |||
|
| this manual. |
|
|
|
|
|
| See the Installation Section of |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely, contact the Lincoln Electric Service Department for technical troubleshooting assistance before you proceed. Call
VRTEX TM 360