Lincoln Electric SVM200-A service manual Figure F.48 Case Back Rear

Return to Section TOC Return to Master TOC

F-103 TROUBLESHOOTING AND REPAIR F-103

TABLE SWING ARM

REMOVAL AND REPLACEMENT PROCEDURE (continued)

FIGURE F.48 – CASE BACK (REAR)

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

REPLACEMENT PROCEDURE

1. Replace the Table Swing Arm.

2. Carefully guide the Table Swing Arm cable through the 1¾” access hole in the case back.

3. Insert the plastic grommet into the 1¾” access hole.

4. Slide the new Table Swing Arm onto the top of the top of the table mounting post.

5. Replace any previously removed cable ties.

6. Install the strain relief from the Table Swing Arm cable previously removed from the rear of the machine.

7. Connect the previously removed cable labeled “SOURCE” to the polhemus module.

8.	Perform		Case	Cover	Replacement
9.	rocedure.
	Perform	the		Monitor	and Pedestal
	Replacement Procedure.
10. See the Retest After Repair.

VRTEX TM 360