Lincoln Electric SVM200-A Tolerances Value Modifying, Tolerances Equipment Settings Screen

B-25 OPERATION B-25

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Return to Section TOC Return to Master TOC

Tolerances Value Modifying

TheOverviewuser can modify the tolerance values. This is done by: 1) Use the joystick to highlight the equipment set- ting or parameter to change. 2) Press the red select button. 3) Use the joystick to change the value. Pressing the green set tolerances button will save the changes.

The following screens are used to modify tolerances:

• Tolerances Equipment Settings screen

• Tolerances Gas screen

• Tolerances Welding Technique Parameters screen

• Tolerances Pattern and Aim screen

• Tolerances Whip and Travel Speed screen

• Tolerances Weave screen

TheNextarrow& Previousbuttons are used to cycle through the toler- ance editor screens.

The configuration and process selected are shown at the top of the screen.

In the upper right of the screen is the name of the tol- erance set being modified.

Ideal values represent the ideal weld technique para- meters. If the user welds using the technique listed as ideal, they will get the best score. The ideal values are represented by the red line on the LASER screen. Changing the +/- changes the acceptable tolerance indicated by the white lines on the LASER screen. Any welding technique used within that +/- range is accept- able but will be scored lower the further it is from the ideal value. As an example, a work angle with an ideal of 45 degrees and a +/-1 of 10 degrees means that the user can use a work angle between 35 and 55 degrees and create an acceptable weld.

Settings that are non-applicable to the process select- ed are greyed out and cannot be changed.

ThisMenuis the same as the tolerance configuration selec- tion screen.

PressingBack back goes to the previous screen without saving changes.

Pressingrev Passthis changes the pass being modified. If this is the first pass, this option is not available. The pass number currently being modified is shown in the upper right of the screen.

ChangesNext Passthe pass being modified to the next pass in the series. If this is the last pass, this option will not be available.

Tolerances Equipment Settings Screen

TOLERANCES EQUIPMENT SETTINGS SCREEN

ThisOverviewscreen allows for the modification of the following welding parameters:

• Wire Feed Speed

• Amperage

• Voltage

• Polarity

Tolerances Gas screen

ThisOverviewscreen allows for the modification of:

• Gas Mixture Selected

• Gas Flow Rate

TOLERANCES GAS SCREEN

VRTEX TM 360