CT-S300 • Setting memory switch 3 (a = 3)
n b (Set Value) Function

• Setting memory with 1 (a = 1)

48 (Default) After clearing cutter error, can be restored by Feed SW.
n b (Set Value) Function 1 49 After clearing cutter error, cannot be restored by Feed SW.
48 (Default) Reports the power on.
1 When selecting cover open error as recoverable error,
recovered by cover close
49 Does not report power on. 48(Default)
48 (Default) Sets input buffer capacity to 4K bytes. 2
2 When selecting cover open error as recoverable error,
recovered by command
49 Sets input buffer capacity to 45 bytes. 49
48 (Default) Sets input buffer full and offline to be Busy.
3 48 (Default) Resets with parallel pin 31.
49 Sets to be busy with input buffer full. 3 49 Does not reset with parallel pin 31.
At the occurrence of receiving error, replaces the data with
“?”.
48 (Default) 48(Default) Uses thermal paper
4 4 49 Uses Black mark paper
49 At the occurrence of receiving error, ignores the data. 48(Default) Used with 48/32 print columns
48 (Default) Disables CR (0DH). 5
5 49 Used with 42/30 print columns
49 Enables CR (0DH).
6 48 (Default) Undefined
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7 49 Resets at serial I/F pin 6.
48 (Default) Does not reset at serial I/F pin 25.
8 49 Resets sat serial I/F pin 25.

• Setting memory switch 2 (a = 2)

n b (Set Value) Function
1 49 (Default) Reserved
48 Disables auto cutter.
2 49 (Default) Enables auto cutter.
48 (Default) Enables stored printing.
3 49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4 49 Immediately after digit reaches full, data wait is taken.
48 (Default) After cover close and PE recovery, prints as it is.
5 49
After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
48(Default) Sets paper width to 80 mm 6
49 Sets paper width to 58 mm
7 48(Default) Reserve
48(Default) Enables PNE.
8 49 Disables PNE.

48 Sets CBM1000-noncompatible mode. 7
49 (Default) Sets CBM11000-compatible mode.
Sets cover open error during printing to be auto recovery
error.
48 (Default)
8 Sets cover open error during printing to be recoverable
error.
49
- 157 -