CT-S4000
• Setting memory switch 4 (a = 4) • Setting memory switch 5 (a = 5)
n b (Set Value) Function n B (Set Value) Function
48 (Default) At the selection of Black mark paper/ label paper, disables
auto end-measurement.
48 (Default) Buzzer sound enabled
1 Buzzer sound disabled 49
1
49 At the selection of Black mark paper/ label paper, enables
auto end-measurement.
48 (Default) Basic calculation pitch (180 dpi / 360 dpi)
2 49 Basic calculation pitch (203 dpi / 406 dpi)
48 (Default) Setting the first position at power ON disabled. 48 USB mode virtual serial
2 3
48 Setting the first position at power ON enabled. 49 (Default) USB mode printer class
48 Paper heading cut disabled. 4 48 (Default) Reserve
3 49 (Default) Paper heading cut enabled. 48 (Default) Reports the power off.
5
48 Uses Black mark paper/ label paper 49 Does not report power off.
4 49 (Default) Uses thermal roll paper 48 (Default) Undefined
6
48 (Default) Detects paper position and black mark. 48 (Default) Undefined
7
5 49 Detects paper position and inter-label distance. 8 48 (Default) Undef ined
Reserved
6 48 (Default)
Reserved
7 48 (Default)
48 Forcible partial cut disabled.
8 Forcible partial cut enabled (full but by command:
enabled).
49 (Default)
*Initial value differs depending on the destination.
Initial value of standard model is roll paper setting.
*Only BM/label model is valid. When roll paper is specified with bit 4, this
bit is invalid.
*When BM paper/label paper is selected, this bit is invalid (full cut at all
times).
- 162 -