CT-S4000
(1) Printer status (When n = 1 is specified) (3) Status caused by an error (when n = 3 is specified)
Bit Status Hex. Decimal Bit Status Hex. Decimal
0 Fixed 00 0 0 Fixed 00 0
1 Fixed 02 2 1 Fixed 02 2
Status of pin 3 of drawer kick-out connector = L 00 0 No B.M detection error occurred 00 0
2 (only when B.M paper is selected)
Status of pin 3 of drawer kick-out connector = H 04 4 2 A B.M detection error occurred
Online status 00 0 04 4
3 (only when B.M paper is selected)
Offline status 08 8 Auto cutter error not occurred 00 0
4 Fixed 10 16 3 Auto cutter error occurred 08 8
Not waiting online recovery 00 0
5 4 Fixed 10 16
Waiting online recovery 20 32 Unrecoverable error not occurred 00 0
FEED switch is not pressed 00 0 5
6 Unrecoverable error occurred 20 32
FEED switch is pressed 40 64 Auto recovery error not occurred 00 0
7 Fixed 00 0 6 Auto recovery error occurred 40 64
7 Fixed 00 0
(2) Status caused by an offline condition (When n = 2 is specified) Bit 3: If this error occurred because of a paper jam, for example, remove
the cause of the error, and then DLE ENQ n (1 n 2) can be used to
recover from the error. However, it is not possible to recover from
any error due to a circuit problem (e.g., broken wire).
Bit Status Hex. Decimal
0 Unused 00 0
1 Unused 02 2
Cover closed 00 0 Bit 6: If a head overheat error is detected, the printing is stopped until the
head temperature falls. At this time, bit 6 = 1.
2 Cover open 04 4
Not in paper feed state triggered by FEED
switch 00 0
3 (4) Continuous paper detector status (When n = 4 is specified)
In paper feed state triggered by FEED switch 08 8 Bit Status Hex. Decimal
4 Unused 10 16 0 Fixed 00 0
Printing is not stopped because of “paper out”
state 00 0 1 Fixed 02 02
5
Paper found by Paper Near-end Sensor 00 0
Printing is stopped because of “paper out” state 20 32 2 Paper not found by Paper Near-end Sensor 04 4
Error not occurred 00 0
6 Paper found by Paper Near-end Sensor 00 0
Error occurred 40 64 3 Paper not found by Paper Near-end Sensor 08 8
7 Unused 00 0
4 Fixed 10 16
Bit 5: Printing is stopped if the Paper-end detector detects a “paper out”
state, or if the printer is out of paper when the Paper Near-end
Sensor is enabled by ESC c 4. At this time, bit 5 = 1.
Paper found by Paper-end Sensor 00 0
5 Paper not found by Paper-end Sensor 60 96
Paper found by Paper-end Sensor 00 0
6
Paper not found by Paper-end Sensor 40 64
7 Fixed 00 0
- 85 -