- 224 -
ESC L CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model PMU2XXX
[Function] Selecting PAGE MODE
[Code] <1B>H<4C>H
[Outline] [The specification which depend on the model]
Switches from STANDARD MODE to PAGE MODE.
[Caution] • This command is only effective if it entered at the beginning of a line.
• This command is not effective if it is entered when in PAGE MODE.
• STANDARD MODE is restored when printing specified by FF is finished or when ESC S is issued.
• The character mapping start position will be the point specified by ESC T in the print area specified
by ESC W.
• The commands listed below, which have separate settings for PAGE MODE and STANDARD
MODE, are changed to the settings for PAGE MODE use.
(1) Spacing setting: ESC SP, FS S
(2) Line feed width setting: ESC 2, ESC 3
• The following commands are valid only in PAGE MODE.
(1) ESC V Specifying/canceling 90°-right-turned characters.
(2) ESC a Aligning the characters.
(3) ESC { Specifying/canceling the inverted characters.
(4) GS L Setting the left margin.
(5) G3S W Setting the print area width.
• The following commands are disabled in PAGE MODE.
(1) GS ( A Executes test printing.
(2) FS p Prints NV memory bit image.
(3) FS q Defines NV memory bit image.
(4) GS v 0 Prints raster bit image.
• ESC @ restores STANDARD MODE.
[See Also] Appendix 5.1.4 “Example of using PAGE MODE”
FF、CAN、ESC FF、ESC S、ESC T、ESC W、GS W、GS
＼