BD2-2220
(1) Printer status (When n = 1 is specified) (3) Status caused by an error (when n = 3 is specified)
Bit Status Hex. Decimal Bit Status Hex. Decimal
0 Fixed 00 0 0 Fixed 00 0
1 Fixed 02 2 1 Fixed 02 2
2 Fixed 04 4 2 Fixed 00 0
Online status 00 0 Auto cutter error not occurred 00 0
3 3
Offline status 08 8 Auto cutter error occurred 08 8
4 Fixed 10 16 4 Fixed 10 16
Not waiting online recovery 00 0 Unrecoverable error not occur red 00 0
5 5
Waiting online recovery 20 32 Unrecoverable error occurred 20 32
LF-SW signal is High-Level 00 0 Auto recovery error not occurred 00 0
6 6
LF-SW signal is Low-Level 40 64 Auto recovery error occurred 40 64
7 Fixed 00 0 7 Fixed 00 0
Bit 3: If this error occurred because of a paper jam, for example, remove the
cause of the error, and then DLE ENQ n (1 n 2) can be used to
recover from the error. However, it is not possible to recover from
any error due to a circuit problem (e.g., broken wire).
(2) Status caused by an offline condition (When n = 2 is specified)
Bit Status Hex. Decimal
0 Unused 00 0
1 Unused 02 2
Head-down 00 0
Bit 6: If a head overheat error is detected, the printing is stopped until the
head temperature falls. At this time, bit 6 = 1.
2 Head-up 04 4
(4) Continuous paper detector status (When n = 4 is specified)
Not in paper feed state triggered by LF-SW
signal 00 0 Bit Status Hex. Decimal
3
In paper feed state triggered by LF-SW signal 08 8 0 Fixed 00 0
4 Unused 10 16 1 Fixed 02 02
Printing is not stopped because of “paper out”
state 00 0 Paper found by Paper Near-end Sensor 00 0
2
5 Paper not found by Paper Near-end Sensor 04 4
Printing is stopped because of “paper out” state 20 32 Paper found by Paper Near-end Sensor 00 0
3
Error not occurred 00 0 Paper not found by Paper Near-end Sensor 08 8
6 Error occurred 40 64 4 Fixed 10 16
7 Unused 00 0 Paper found by Paper-end Sensor 00 0
5
Bit 5: Printing is stopped if the Paper-end detector detects a “paper out”
state, or if the printer is out of paper when the Paper Near-end
Sensor is enabled by ESC c 4. At this time, bit 5 = 1.
Paper not found by Paper-end Sensor 60 96
Paper found by Paper-end Sensor 00 0
6 Paper not found by Paper-end Sensor 40 64
7 Fixed 00 0
- 86 -