Basic Operations

Housing the liquid crystal panel

Adjusting the AUDIO

English

1.Press the [OPEN] button and the liquid crystal panel is housed automatically.

Note:

•When leaving this unit unused for a long period of time or leaving your car, be sure to house the liquid crystal panel into the main unit.

Note:

•When the separately-sold 5.1 ch Surround Decoder (DVH940) is used, the bass and treble tone adjustments cannot be made. To adjust the tone, refer to the section “5.1 ch Surround Decorder Operations”.

manual Owner’s

Turning the liquid crystal panel horizontal (Air conditioner operation mode)

When the way the liquid crystal panel is mounted hinders the operation of the air conditioner, the position of the panel can be turned horizontal temporarily.

1.Press and hold the [OPEN] button when the liquid crystal panel is upright, and release the button when a beep is heard.

2.The liquid crystal panel turns horizontal.

∗Press the [OPEN] button again when the liquid crystal panel is in the horizontal position, and the panel returns to the original position.

∗The unit can also be set so that the panel returns to its original angle after a set time in the horizontal position (See P. 28).

Mute

1.When in the radio, VISUAL or TV mode, each time you press the [MUTE] button, mute is turned on and off. “MUTE” appears when mute is turned on.

2.In modes other than radio, VISUAL, or TV, enable the MUTE function by holding the [MUTE] button depressed for 1 second or longer.

Regarding the menu screen’s [RTN] and [ESC] keys

•[RTN]: Touch the [RTN] key to return to the previous screen.

•[ESC]: Touch the [ESC] key to return to the main screen.

In the ADJUST MODE, pressing the [ADJ] button will also cause a return to the main screen.

In cases where this kind of multiple key response is supported, the following kind of notation will be used:

Touch the [RTN] key, [ESC] key, or press the [ADJ] button.

Adjusting the balance/fader

1.Press the [ADJ] button, then touch the [AUDIO] key.

2.Touch the [BAL/FAD] key.

3.Touch the [w] or [z] key to adjust to the fader level.

∗The factory default setting is “0”. (Adjustment range: front 13 to rear 13)

[w] key : Emphasized the sound from the front speakers.

[z] key : Emphasized the sound from the rear speakers.

4.Touch the [Å] or [Î] key to adjust to the balance level.

∗The factory default setting is “0”. (Adjustment range: left 12 to right 12)

[Å] key : Emphasized the sound from the left speakers.

[Î] key : Emphasized the sound from the right speakers.

5.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.

Adjusting the BASS

The bass gain, bass frequency (center frequency) and bass Q can be adjusted as follows.

1.Press the [ADJ] button, then touch the [AUDIO] key.

2.Touch the [BASS] key.

3.When the bass type selection screen is displayed, touch the key for the desirable type to select it.

4.Touch the [w] or [z] key to adjust to desirable level.

GAIN : –6 to 8 (The factory default setting is “0”)

FREQ. : 50Hz/80Hz/120Hz (The factory default setting is “50”)

Q: 1/1.25/1.5/2 (The factory default setting is “1”)

5.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.

VRX756VD 25