Clarion VRX756VD 6.REMOVING THE MAIN UNIT, 7.CAUTIONS ON WIRING

6. REMOVING THE MAIN UNIT

1.	When the rear of the main unit has been	pull the main unit out by the hook plate.
	secured with the method shown in Figure 6	(Insert both the right and left edges of the
	unfasten the special screw.	hook plate.) (Figure 9)
2.	Remove the outer escutcheon.
3.	Insert the hook plate between the spring and	Note: Keep the hook plate. You cannot remove the
	the universal mounting bracket, fit tab B of	main unit without disengaging the hook plate.
	the spring into hole A of the hook plate, then

English connectionmanual Installationand Wire

Universal mounting bracket	Instrument panel
2-Hook plate
	Main
	Unit
	Spring

Outer escutcheon

AB

Figure 9

7. CAUTIONS ON WIRING

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

Note: There are various types of fuse holder. Do not let the battery side touch other metal parts.

CAUTION

After the connection, fix the lead by a clamp or insulation tape for protection.

3. If the fuse should blow, check to see if the wiring is correct.

If it is, replace the fuse with a new one with

the same amperage rating as the original

(15A FUSE).

Fuse (15A FUSE)

4. To replace the fuse, remove the old fuse of

the power supply lead and insert the newFuse holder one. (Figure10)

Figure 10

VRX756VD 69