English
Basic Operations
Adjusting the GENERAL | ON: The liquid crystal panel houses |
| automatically after removing the |
| |
Setting the BEEP | DCP. |
manual Owner’s
∗The sound heard when you make operations is called “beep”. The unit can be set up so that it does not produce this beep sound.
∗The factory default setting is “BEEP ON”.
1.When the panel is open, press the [ADJ] button to select the ADJUST MODE menu.
2.Touch the [GENERAL] key.
Touch the [BEEP] key to select “ON” and “OFF”.
3.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.
Setting the button illumination
∗The factory default setting is “GREEN” (green).
1.When the panel is open, press the [ADJ] button to select the ADJUST MODE menu.
2.Touch the [GENERAL] key.
3.Touch the [KEY ILLUMI] key to select “RED” (red) or “GREEN” (green).
4.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.
Clock Adjustment
1.When the panel is open, press the [ADJ] button to select the ADJUST MODE menu.
2.Touch the [GENERAL] key.
Touch the [CLOCK] key to adjust the time.
3.Touch the [w], [z], [a.m] or [p.m] key to adjust the time, then touch the [SET] key.
∗ The time is displayed in
4.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.
And the liquid crystal panel open automatically after attaching the DCP.
OFF: Normal operation.
CLOSE: The liquid crystal panel houses automatically after removing the DCP.
3.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.
Switching CONNECT(connect)
Make the following settings when an external device is connected to the Visual terminal.
NAVI: when a navigation system is connected
∗When a navigation system is connected, use the monitor lock function. Locking the monitor locks the screen size in F.WIDE mode (full wide) and the VTR system to NTSC.
OTHERS: for external devices other than a navigation system
NONE: when no external devices are connected
∗The factory default setting is “NONE”.
1.When the panel is open, press the [ADJ] button to display the ADJUST MODE menu.
2.Touch the [GENERAL] key.
Touch the [CONNECT] key to select “NAVI” or “OTHERS” or “NONE”.
3.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.
Setting the Auto Panel
When you remove or attach the DCP, you can set the liquid crystal panel automatically housing or opening.
∗The factory default setting is “ON”.
1.Press the [ADJ] button to select the ADJUST MODE menu.
2.Touch the [GENERAL] key.
Touch the [AUTO PANEL] key to set “ON”, “OFF” or “CLOSE”.
Time setting in air conditioner operation mode
This setting can be used to adjust the time the panel stays in the horizontal position when in the air conditioner operation mode.
∗The factory default setting is “10s”. 1. Press the [ADJ] button.
2.Touch the [GENERAL] key.
3.Touch the [HVAC MODE] key to set to “5s,” “10s,” or “30s.”
4.Touch the [RTN] key, [ESC] key, or press the [ADJ] button.
28 VRX756VD