English

 

Basic Operations

 

crystal panel

 

 

Opening and turning the liquid

 

 

 

 

 

WARNING

Owner’s

 

operate this unit with the engine running,

 

 

• To prevent the battery from going dead,

manual

 

if possible.

 

• When the liquid crystal panel is operat-

 

 

 

 

ing, be careful not to get your hand or fin-

 

 

 

ger caught between the panel and main

 

 

unit or the instrument panel of the car.

 

 

• Do not move the liquid crystal panel by

 

 

hand.

 

 

 

Standing up the liquid crystal panel

1.Press the [OPEN] button and the liquid crystal panel comes out and stand up automatically.

∗While the liquid crystal panel is opening or closing, the blue LED of the [SOURCE] button (and other buttons) will flash.

Notes:

•If the liquid crystal panel stops in the middle of its operation, press the [OPEN] button to house the panel and press the button again to stand it up.

The unit enters the same display mode as the display was turned off the last time.

•If the liquid crystal panel stops at any point less than 70°, the electronic beep will sound.

70˚

Panel calibration function

The liquid crystal panel’s maximum angle of inclination can be adjusted to match the installation configuration within the automobile.

• Perform this with the panel in its closed position.

1.Deeply push in [FRONT OPEN] button to unlock the front panel.

2.Press and hold the [TILT] button for 2 seconds or longer, until the electronic beep is heard.

3.The beep will sound twice, and the panel will rise and the calibration function will begin.

4.After completion of the calibration, the panel will close automatically.

∗If the panel does not strike the instrument panel or other parts of the car during calibration, the maximum inclination will be 110°.

∗If the panel strikes a car part during calibration within a range of 70° inclination, the maximum downward inclination will be 70°.

Adjusting the angle of the liquid crystal panel

The angle of the liquid crystal panel can be adjusted depending on the mounting angle of the unit or light coming into the car.

●To adjust the angle

1.Every time the [TILT] button is pressed, the liquid crystal panel tilts forward or backward. The adjusted angle is stored in memory.

∗Adjustment is possible within the range 70° to 110°, or within the range set by panel calibration.

∗There are 5 adjustable angle available.

MAX110˚

24 VRX756VD