PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 9
Getting Started
E
6.Set the TONE/PULSE switch located on the back of the base to correct dialing mode. Please check with your local Phone Company if uncertain of the type of service.
7.Place handset in the cradle to begin initial charging.
WALL MOUNTING INSTRUCTIONS
The base unit may be mounted on a standard wall plate.
1.With the back of the unit facing up insert the supplied mounting bracket’s tabs into the base’s lower tab slots in then direction of WALL MOUNT marked on the bracket, then press down on the brackets clips and insert them into the clip slots.
2.Plug one end of the supplied short modular telephone line cord into the TEL jack located on the back of the base of the phone.
3.Insert the plug of the AC adapter into the jack marked DC 9V 400mA located on the back of the telephone base.
4.Route the adapter’s cord through the narrow groove located on the back of mounting bracket to secure the cord.
5.Plug the short modular telephone line cord into the wall plate jack, then align the mounting bracket’s keyhole slots with the wall plate studs and slide the base of the phone downward to secure it on the wall.
6.Plug the adapter into a standard AC power (electrical) outlet.
7.Press and lift out the handset holder tab, turn it around so the narrow tab end extends out and slide back into its slot. This will hold the handset in the cradle when the phone is wall mounted.
8.Lift the base’s antenna to a vertical position.
9.Set the Tone/Pulse switch located on the back of the base to correct dialing mode. Please check with your local Phone Company if uncertain of the type of service.
10.Place handset in the cradle to begin initial charging. Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
Note: Remember, you must charge the phone for at least 12 hours before you use the phone for the first time.
N G L I S H
9
