Cleveland Range 22CET6.1, 22CET3.1 Filter Washer 110987 Shown Test Water Supply Lines

water to supply the reservoir. To use a separate conditioned water supply, use the layout shown in Figure 3-11.

i.The steamer has two 3/4-inch GHT fittings, one for the water reservoir and one for the condenser. See Figures 2-1 and 2-2.

A Filter Washer (dirt filter) is supplied installed in each of the water inlets. See Figure 3-9.

1.Construct all supply lines up to the 3/4-inch NHT fittings.

2.Flush the water supply lines before connecting them to the 3/4-inch fittings.

Figure 3-9

Filter Washer

(P/N 110987 Shown)

3.Test Water Supply Lines

a.Check all connections for proper tightness.

b.Remove the control side panel to inspect water connections inside the steamer.

c.Open the water supply valves.

d.Check all lines and connections for leaks, both inside and outside the steamer.

SteamChef

Condenser

Water Reservoir

Water Connection

Air/Water Column

(if required)

Check Valve

Main Cold

Water Supply

Water Connection	Pressure Reducer	Main Water
	(if required)	Shutoff Valve

Figure 3-10 Cleveland Range Single Water Supply Arrangement

SteamChef

Condenser

Water Reservoir

Water Connection

Water Connection

Check Valve

Pressure Reducer (if required)

Air/Water Column (if required)

Cold Tap Water Supply

Main Water

Shutoff Valve

Conditioned* Cold

Water Supply

Figure 3-11 Cleveland Range Separate Water Supply Arrangement when Using

Separate Conditioned Feed Water Supply

*“Conditioned” indicates water that has been filtered or treated by a Cleveland Range approved method to meet or exceed the water quality standards listed in the Warranty

12