Programming the Fpga | Connect Tech 104 instruction

Connect Tech FreeForm/PCI-104 User Manual

Programming the FPGA

1)Right click on device number one (Virtex-5 FPGA), and select program. The following diagram will appear. Note that verification will only work if an msk file has been created.

2) Select OK to begin programming. After programming is complete, the status window will report:

Revision 0.00

16

Image 16

Connect Tech 104 user manual Programming the Fpga

Contents

FreeForm/PCI-104 Copyright Notice Limited Lifetime WarrantyTrademark Acknowledgment Customer Support Overview Contact InformationTelephone/Facsimile Email/Internet Table of Contents List of Tables List of Figures Features Introduction Jumpers /Switches Description Components Description Hardware Description and Configuration Jumpers and SwitchesSlot Selection RSW1 Position Fpga Configuration Settings J1 Slot Selection RSW1 Connector Pinouts External Power Connector Pinout P8 Signal Direction External Power Connection Gpio Header Pinout Signal Direction Gpio Header P7 Hardware Installation Software InstallationStandalone Operation Fpga Development Environment Fpga Configuration Launch ImpactPage Page Programming the Fpga Generating a Prom MCS File Page Revision Configuring the Fpga with the SPI Flash Configuring the Fpga / SPI flash AssociationPage Programming the Flash Elapsed time = Reference Design FunctionalityMemory Map Bar Local Address Space 0 Bar Implementation Local Address Space 1 Bar Specifications