Connect Tech PCI-104 Hardware Description , Jumpers and Switches

Connect Tech FreeForm/PCI-104 User Manual

Revision 0.02 10

Hardware Description

The following sections describe the function of all switches/jumpers and provide details on connector

pinouts.

Jumpers and Switches

Slot Selection (RSW1)

This rotary switch selects a slot position in the PCI-104 stack. When mounting on a PCI adapter

card, ensure slot one is selected.

Table 2: Slot Selection (RSW1)

Position Slot

0,4 0

1,5 1

2,6 2

3,7 3

FPGA Configuration Settings (J1)

Jumper J1 is used to control FPGA configuration.

Table 3: FPGA Configuration Settings (J1)

Location Function

FPGA waits for configuration over JTAG (using P2)

FPGA reads configuration from SPI flash

FPGA is tri-stated, flash is isolated from FPGA and

can be programmed directly

Contents

Main FreeForm/PCI-104 User Manual Limited Lifetime Warranty Copyright Notice Trademark Acknowledgment Customer Support Overview Table of Contents List of Tables List of Figures Introduction Product Features About this manual Connect Tech FreeForm/PCI-104 User Manual System Overview Figure 1: FreeForm/PCI-104 Block Diagram Page Reference Design Hardware Description Jumpers and Switches Connector Pinouts P2 P3 Page P4 P5 P6 Page P8 Connectors Mating Components and Cables Hardware Installation Heat Sink Installation WARNING Stand-alone Operation WARNING Software Installation FPGA Development Environment PLX Software Development Kit (SDK) Reference Design & Application Examples FPGA Configuration Power and Thermal Considerations Reference Design FPGA power analysis Specifications Appendix A: iMPACT Instructions for FPGA Configuration Launch Impact Page Page Programming the FPGA Generating a PROM (MCS) File Page Page Configuring the FPGA with the SPI Flash Page Page Page Page Page Page Appendix C: Hardware Changes from Revision B Connect Tech FreeForm/PCI-104 User Manual Revision 0.02 37 Reference Design DDR2 Pinout Hardware Description P5 P5 Specifications