Connect Tech PCI-104 Hardware Installation, Heat Sink Installation, Stand-alone Operation

Connect Tech FreeForm/PCI-104 User Manual

Hardware Installation

Before installing the FreeForm/PCI-104 into a PCI-104 stack, ensure the following:

oSlot selection is properly set using the rotary switch RSW1. o FPGA configuration jumper J1 is set to read from flash.

Once installed in the system and power is applied, the LED D1 will illuminate to indicate that FreeForm/PCI-104 is functioning.

Heat Sink Installation

Each FreeForm/PCI-104 ships with a FPGA heat sink (27 mm x 27 mm); to be installed by the user. Simply peel of the sticker backing and press firmly onto the FPGA, using proper ESD precautions.

If the heat sink size is not suitable for your application, please contact Connect Tech Inc.

WARNING In many applications, including high speed memory operations, the FPGA dissipates a significant amount of power. Failure to use any heat sinking will result in the product warranty being voided.

Stand-alone Operation

Operating the FreeForm/PCI-104 outside of a PCI-104 stack or a PCI system for extended periods of time is not recommended. The PCI to local bus bridge (PCI PLX 9056) requires the pull-up/pull-down resistors provided on a system’s main board.

Configuring or programming the FreeForm/PCI-104 in stand-alone mode is acceptable, providing that it is not left powered on in stand-alone state for an extended period of time.

WARNING The power supply MSG037 included with the development kit DEV002 is intended for desktop programming only. It is not intended or warranted to be used in any other situation.

Revision 0.02 17