CPG SP40 manual Printing the Test, Self Test

•Print one of the Printer Setup Forms (Configuration Menu or Program1/Program2 Menu) or the Offset Tuning Form. See “ Printing the Printer Setup Forms” later in this manual

•Insert a filled-in Printer Setup Form to set the corresponding Setup values.

Printing the Test Page

The Self Test page is useful to test, if the printer has been correctly installed, and allows to see the current parameter settings.

1.With the printer in the Setup Mode, insert a single sheet in A4 or Letter format.

2.The printer loads the sheet and stops.

3.Press the ON LINEkey again.

The printer prints the Self-Test page. Check that the printout is correct. The following printout example shows the Printer Setup default values.

Once the self-test is finished, the printer remains in Setup Mode.

SELF TEST

SP-40 :Code Version Vx.x xxxxxxxx CharGen:xxxxxxxx ver. x.xx

CONFIGURATION SETUP

PROGRAM	progr.1	AUTOFEED SIGNAL	disabled
ERROR BUZZER	1 beep	SLCT-IN SIGNAL	disabled
JOB BUZZER	no beep	IGNORE PE	enabled
SECURITY MODE	enabled	BUFFER CONTROL	XON/XOFF
PASSBOOK TYPE	vertical	ROBUST XON	enabled
GET EDGE QUOTE	1/2”	WORD LENGTH	8 bit
INTERFACE TYPE	automatic	BAUD RATE	9600 bps

24