BEFORE LEAVING THE SAW
●Never leave tool running unattended. Turn power OFF. Wait for all moving parts to stop.
●Make workshop childproof. Lock the shop. Disconnect master switches. Store tool away from children and other unqualified users.
!WARNING
To avoid injury from materials being thrown, always unplug the saw
to avoid accidental starting, and remove small pieces of material from the table cavity.
MITER CUT (FIG. CC)
1.When a miter cut is required, unlock the miter table by releasing the miter lock lever (1).
2.While holding the miter handle (2), press down on the positive stop locking lever (3).
3.Rotate the miter table to the right or left with the miter handle.
4.When the table is in the desired position, as shown on the miter scale (4), release the positive stop locking lever and tighten the miter handle. The table is now locked at the desired angle. Positive stops are provided at 0°, 15°, 22.5°, 31.6° and 45°.
IMPORTANT: Always lock the miter lock lever before performing a cut.
Fig. CC
BEVEL CUT (FIG. DD)
1.When a bevel cut is required, loosen the bevel lock handle (1) by turning it clockwise.
2.Tilt the cutting head to the desired angle, as shown on the bevel scale (2).
3.The blade can be positioned at any angle, from a 90° straight cut (0° on the scale) to a 45° left/right bevel.
Tighten the lock handle (1) to lock the cutting head in position. Positive bevel stops are provided at 0° and 45°.
Fig. DD
1
2
33.9° CROWN MOULDING (FIG. EE) NOTE: When cutting crown moulding, the bevel angle should be set 33.9° right or left.
1.Loosen the bevel lock handle (1),
2.Rotate the bevel stop block (2) and set bevel angle at the 33.9° position.
3.Tilt the cutting arm to the left or right.
Fig. EE
1
|
| 4 | 33.9° | 2 |
1 | 2 | 3 | ||
|
|
| ||
|
|
|
|
34 
