ASSEMBLY
!WARNING
To avoid injury, do not connect this miter saw to the power source until it is completely assembled and adjusted and you have read and understood this Operator’s Manual.
INSTALLING THE MITER HANDLE (FIG. A)
1.Thread the miter handle (1) into the hole (2) located at the front of the miter table.
Fig. A
2
1
2.Pull out the stop latch knob (2).
3.Allow the cutting head to rise to the up position.
Locking
When transporting or storing the miter saw, the cutting head should always be locked in the down position.
1.Push the cutting head down to its lowest position.
2.Push the stop latch knob (2) into the locking hole.
Fig. B
1
!WARNING
●To avoid injury and damage to the saw, transport or store the miter saw with the cutting head locked in the down position. Never use the stop latch to hold the cutting head in a down position for cutting operations.
●To avoid damage, never carry the miter saw by the switch handle, the cutting arm or the miter table handle. Always use the designated carrying handle.
CUTTING HEAD (FIG. B)
Raising
1.Push down slightly on the switch handle (1).
2
INSTALLING THE DUST BAG (FIG. C)
1.Squeeze the metal collar wings (1) of the dust bag (2).
2.Place the dust bag neck opening around the exhaust port (3), and release the metal collar wings.
Fig. C
2 
1
3
18 
