Craftsman 137.37564 manual Right Bevel Adjustment Fig. S, Fig. S Left Bevel Adjustment Fig. T

33.9° Right Bevel Adjustment (Fig. S)

1.Set the miter angle to 0°. Fully extend both sliding fences.

2.Loosen the bevel lock handle (1).

3.Set the stop block (2) at 33.9° position by turning the lever (3) clockwise.

4.Using a combination square, check to see if the blade is 33.9° to the table.

5.If the blade is not 33.9° to the miter table, tilt the cutting arm to the left, loosen the locknut (4) on the stop block (2), and turn the bolt (5) in or out with a hex wrench until the blade is 33.9° to the table.

Fig. S

5

4

1

3 2

33.9° Left Bevel Adjustment (Fig. T)

1.Set the miter angle to 0°. Fully extend both sliding fences.

2.Loosen the bevel lock handle (1).

3.Set the stop block at 33.9° position by turning the lever (2) clockwise.

4.Using a combination square, check to see if the blade is 33.9° to the table.

5.If the blade is not 33.9° to the miter table, tilt the cutting arm to the right, loosen the locknut (3) on the stop block (5), and turn the bolt (4) in or out with a hex wrench until the blade is 33.9° to the table.

Fig. T

1

	2	5
3
	4

! WARNING

To avoid injury from unexpected saw movement:

Before moving the saw, disconnect the power cord from the outlet and lock the cutting arm in the lower position using the stop latch.

NOTE: The stop latch is for carrying or storing the tool. It is NOT to be used for holding the saw while cutting.

●Never carry the miter saw by the power cord or by the switch handle. Carrying the tool by the power cord could cause damage to the insulation or wire connections, resulting in electric shock or fire.

●To avoid injury from flying debris, do not allow visitors to stand behind the saw.

●Place the saw on a firm, level work surface where there is room for handling and proper support for the workpiece.

●Support the saw on a level work surface.

●Bolt or clamp the saw to its support.

25