TO REPLACE MOWER BLADE DRIVE BELT
The mower blade drive belt may be replaced without tools. Park the tractor on level sur- face. Engage parking brake.
BELT REMOVAL -
1.Remove mowerfromtractor (See “TO RE- MOVEMOWER”inthissectionofmanual).
2.Work belt off both mandrel pulleys and idler pulleys.
3.Pull belt away from mower.
BELT INSTALLATION -
1.Work belt around both mandrel pulleys and idler pulleys
2.Ensure belt is in all pulley grooves and inside all belt guides.
3.Install mower (See “To Install Mower” in this section of this manual).
MandrelIdler
PulleyPulleys
Mandrel
Pulley
TO REPLACE MOTION DRIVE BELT
BELT INSTALLATION -
1.Install new belt from tractor rear to front, over the steering plate (F) and above clutch brake pedal shaft (G).
2.Pull belt toward front of tractor and roll belt onto engine pulley (E).
3.Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pulley (D). Ensure belt is inside the belt keeper.
4.Install belt on centerspan idler (C).
5.Install belt through stationary idler (A) and clutching idler (B).
6.Ensure belt is in all pulley grooves and inside all belt guides and keepers.
7.Install mower (See “TO INSTALL MOW- ER” in this section of manual).
| E |
| F |
A |
|
B |
|
C | G |
|
D 
FAMILIARICESE CON SU TRACTOR
LEA ESTE MANUAL DEL DUEÑO Y LAS REGLAS DE SEGURIDAD ANTES DE OPERAR SU TRACTOR
Compare las ilustraciones con su tractor para familiarizarse con las ubicaciones de los diversos controles y ajustes. Guarde este manual para referencia en el futuro.
D
HE
B
CG
F
J
A
M
Nuestros tractores cumplen con los estándares de seguridad del
American National Standard Institute.
Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.
BELT REMOVAL -
1.Remove mower (See “TO REMOVE MOWER” in this section of manual).
NOTE: Observe entire motion drive belt and position of all belt guides and keepers.
2.Remove belt from stationary idler (A) and clutching idler (B).
3.Remove belt from centerspan idler (C).
6.Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cool- ing fan blades (D).
4.Remove belt downward from engine pulley (E).
5.Slide belt toward rear of tractor, off the steering plate (F) and remove from tractor.
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.
You may also check brake by:
1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.
2.Disengage transmission by placing freewheel control in “transmission dis- engaged” position. Pull freewheel control out and into the slot and release so it is
held in the disengaged position.
The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a Sears or other qualified service center.
(A)PALANCA DEL LEVANTAMIENTO DEL AC- CESORIO - Se usa para levantar, bajar y ajustar el conjunto segador o los demás accesorios montados en su tractor.
(B)PEDAL DEL EMBRAGUE/FRENO - Se usa para desembragar y frenar el tractor y para hacer arrancar el motor.
(C)PALANCA DEL FRENO DE ESTACIONA- MIENTO - Asegura el pedal del embrague/freno en la posición del freno.
(D)CONTROL DE ACELERACIÓN - Se usa para controlar la velocidad del motor.
(E)PALANCA DEL EMBRAGUE DEL AC- CESORIO - Se usa para enganchar las cuchillas segadoras, o los demás accesorios montados en su tractor.
(F)INTERRUPTOR DE IGNICIÓN - Se usa para hacer arrancar o hacer parar el motor.
(G)SISTEMA DE FUNCIONAMIENTO HACIA ATRÁS (ROS) en posición “ON” - Permite la operación del conjunto segador o otro accesorio accionado mientras que en revés.
(H)INTERRUPTOR DE LA LUZ - Enciende y apaga las luces delanteras.
(J)PALANCA DE MANDO CRUCERO - Se utiliza para fijar el movimiento hacia adelante del tractor a la velocidad deseada sin apretar el pedal de marcha atrás.
(M)CONTROL DE RUEDA LIBRE - Desengan- cha la
24 | 41 |
