CyberPower Systems CPS1500AVR user manual Definitions for LED Indicators, Avr

CPS1500AVR

Guaranteed Uninterruptible Power System

DEFINITIONS FOR LED INDICATORS

Power On	Wiring	AVR	Using	Circuit	Alarm	Condition
	Fault		Battery	Breaker
On	Off	Off	Off	Set	Off	Normal
On	Off	Flash	Off	Set	Off	AVR - Max. boost 15% of input voltage for output regulation
						while input voltage is from 8% to 30% under nominal.
On	Off	On	Off	Set	Off	AVR - Max. buck 15% of input voltage for output regulation
						while input voltage is from 8% to 26% over nominal.
Off	On/Off	Off	On	Set	Two Beeps	Utility Failure - The UPS is providing battery power to the
						battery outlets.
Off	On/Off	Off	On	Set	Rapid Beeps	Utility Failure - The UPS is providing battery power to the
						battery outlets. Rapid beeps indicate that the battery will run
						out of charge within a few minutes.
On/Off	On/Off	On/Off/Flash	On/Off	Set	Long Beep	Overload - Turn the UPS off and unplug at least one piece of
						equipment. Wait 5 seconds, reset the circuit breakers and
						restart the UPS.
Off	Off	Off	On	Up	Long Beep	Overload - Turn the UPS off and unplug at least one piece of
						equipment. Wait 5 seconds, reset the circuit breakers and
						restart the UPS.
Off	Off	Off	Off	Set	Off	Surge Protection Malfunction - Power surge has damaged
						the unit. Please contact CyberPower Systems.
On/Off	On/Off	On/Off/Flash	On/Off	Set/Up	None	Electrical Wiring Fault - Indicates a wiring problem such as a
						bad ground, missed ground or reversed wiring within the AC
						outlet. User is advised to disconnect all equipment from the
						outlet and have it checked by an electrician.

The load indicator LED will turn red if the load is between 80 and 100%.

If the load or battery charge is under 20%, no indicator LED will illuminate.

13