© 2007 Cypress Solutions
Installation and Operation Manual: CTM-130 / CTM-132 (Revision 1.2)
Page - 4 -
Due to the nature of wireless communication the reception of data can never be guaranteed. D ata may
be delayed, corrupted or never received. Although such conditions are rare with well-constructed and
configured wireless networks when used in conjunction with devices such as the CTM-130/132 wireless
data modem, such systems should not be used in situations where the reception of data is critical to
personal safety or property integrity. Cypress Solutions Inc. accepts no responsibility for damages of any
kind including but not limited to personal injury, death, or loss of property due to the delay or loss of
data resulting from the use of the CTM-130/132 wireless data modem.
1.1 Operation in hazardous environments
THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS I DIVISION 2 GROUPS A,B,C AND D OR NON
HAZARDOUS LOCATIONS ONLY
Wireless transmitters can cause interference with some critical operation equipment. For this reason it
is required that the CTM-130/132 wireless data modem be turned off when in the vicinity of blasting
operations, medical equipment, life support equipment, or any other equipment that is susceptible to
radio interference.
1.2 Operation in or around aircraft
The CTM-130/132 wireless data modem must be turned off when on-board or in the vicinity of any
aircraft. The FAA prohibits the use of wireless transmitter equipment at any time during aircraft flight.
1.3 Regulatory restrictions
CAUTION: Any modifications to the CTM-130/132 wireless data modem not expressly authorized by
Cypress Solutions Inc. may cause its regulatory approval status to become invalidated, thereby voiding
your authority to use the product.
The CTM-130/132 wireless data modem is approved under FCC CFR 47 part 2.1091 and Industry Canada
RSS-102 rules for operation as a mobile or fixed device with its specified antenna from which a
separation distance of at least 20cm (8”) must be maintained from all persons at all times and during all
modes of operation. The antenna used must not be co-located or operated in conjunction with any
other antenna or transmitter. These rules are in place to prevent any possible hazard du e to personal
exposure to electromagnetic radiation.
FCC ID: OVFKWC-M200
Industry Canada ID: IC:3572A-M200