STK17T88
Document Number: 001-52040 Rev. *A Page 3 of 22
Absolute Maximum Ratings
Voltage on Input Relative to Ground.................–0.5V to 4.1V
Voltage on Input Relative to VSS...........–0.5V to (VCC + 0.5V)
Voltage on DQ0-7 or HSB......................–0.5V to (VCC + 0.5V)
Temperature under Bias...............................–55°C to 125°C
Junction Temperature...................................–55°C to 140°C
Storage Temperature....................................–65°C to 150°C
Power Dissipation.............................................................1W
DC Output Current (1 output at a time, 1s duration)....15 mA

RF (SSOP-48) Package Thermal Characteristics

θjc 6.2 C/W; θja 51.1 [0fpm], 44.7 [200fpm], 41.8 C/W [500fpm]
Note: Stresses greater than those listed under “Absolute
Maximum Ratings” may cause permanent damage to the device.
This is a stress rating only, and functional operation of the device
at conditions above those indicated in the operational sections
of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
reliability.
Note:The HSB pin has IOUT=-10uA for VOH of 2.4V, this parameter is characterized but not tested.
Note:The INT is open-drain and does not source or sink high current when interrupt Register bit D3 is below.
DC Characteristics
(VCC = 2.7V-3.6V)
Symbol Parameter Commercial Industrial Units Notes
Min Max Min Max
ICC1Average VCC Current 65
50 70
55 mA
mA tAVAV = 25 ns
tAVAV = 45 ns
Dependent on output loading and cycle rate.
Values obtained without output loads.
ICC2Average VCC Current
during STORE 3 3 mA All Inputs Don’t Care, VCC = max
Average current for duration of STORE
cycle (tSTORE)
ICC3Average VCC Current
at tAVAV = 200ns
3V, 25°C, Typical
10 10 mA W (VCC
– 0.2V)
All Other Inputs Cycling at CMOS Levels
Dependent on output loading and cycle rate.
Values obtained without output loads.
ICC4Average VCAP
Current during
AutoStore™ Cycle
3 3 mA All Inputs Don’t Care
Average current for duration of STORE cycle
(tSTORE)
ISB VCC Standby Current
(Standby, Stable
CMOS Levels)
33mAE
≥ (VCC -0.2V)
All Others VIN0.2V or (VCC-0.2V)
Standby current level after nonvolatile cycle
complete
IILK Input Leakage
Current ±1±1µAV
CC = max
VIN = VSS to VCC
IOLK Off-State Output
Leakage Current ±1±1µAV
CC = max
VIN = VSS to VCC, E or G VIH
VIH Input Logic “1”
Voltage 2.0 VCC + 0.5 2.0 VCC + 0.5 V All Inputs
VIL Input Logic “0”
Voltage VSS –0.5 0.8 VSS –0.5 0.8 V All Inputs
[+] Feedback