D-Link DSL-1500G SHDSL Ethernet Router User’s Guide, Item Name, State, Pass or Block, Protocol

DSL-1500G SHDSL Ethernet Router User’s Guide

Define these variables for each filter rule:

	When adding a new rule, choose the Not selected option from the drop-
Select index to set	down menu first. This will automatically assign the next available index
	number to the new rule. If you are deleting or modifying an existing rule,
	select it and click the appropriate button to the right.
Item Name	Name filtering rule defined here.
State	Select Enabled to start using the static route when it is applied. To save a
	route you do not want to use now for later use without deleting it you can
	choose Disabled.
Pass or Block	Choose Block to drop packets as defined by the rule. The default Pass will
	route data without restriction as a normal packet.
Interface	Choose Ethernet or select a WAN interface. If you have a single PVC and
	have not modified the name of the WAN interface, it appears here as ISP1
	(the default name for the WAN interface).
Protocol	Select ICMP, TCP, UDP or All to pass or block packets of that protocol type.
Source	Type in the source IP address and select the Subnet Mask to pass or block
	packets form that IP address.

<	specifies the port numbers less than and equal to the Start Port number
>	specifies the port numbers greater than and equal to the Start Port number

=sets the port number equal to the Start Port if there is no End Port specified; if an End Port number is specified, this defines a range of ports to filter. The range is defined as the port numbers between the Start Port and End Port, including the Start and End Port numbers.

Start Port	For a range of ports, this will be the first port in the range. For a single port
	enter the port number.
End Port	For a range of ports, this will be the last port in the range. For a single port
	just enter the same port number entered in Start Port.
Destination	Type in the destination IP address and select the Subnet Mask to pass or
	block packets destined to that IP address.

To delete or modify an existing rule, select the index number and click the action button for Delete or Modify. Clicking on the Clear button will set the variables to the blank or default setting.

Each new rule that is added will appear in the entry table at the top of the web page. When you have configured all the rules you want to use, click on the Apply button. You can save and reboot the system now, or continue to configure the Router.

32