Daewoo DF-8100 user manual Technicali l Specificationsi i ions

Troubleshooting

Symptom Cause Solution

Technicali l Specificationsi i ions

General

	Discs recorded with copy-once
	material cannot be played on other
Cannot record or did not	players.
	The remaining blank space on the
record successfully.	disc is insufficient.
	The source you are trying to record is
	copy-protected.
	When setting the recording channel,
	the channel is tuned on your TV’s
Timer Recording not	tuner.
	Clock in DVD Recorder+VCR is not set
possible.	to correct time.
	Timer has been programmed
	incorrectly.
	TIMER indicator light does not appear
Stereo Audio Record	after programming timer.
	TV is not Stereo-compatible.
and/or Playback not	Broadcast program is not in stereo
present.	format.
	DVD Recorder+VCR A/V Out jacks are
	not connected to TV A/V In jacks.
	DVD Recorder+VCR Audio/Video Out is
	not selected for viewing at the TV.
	DVD Recorder+VCR’s TV audio
	channel is set to BIL or MONO.
	The remote control is not pointed at
	the remote sensor of the DVD
Remote control does not	Recorder+VCR.
	The remote control is too far from the
work properly.	DVD Recorder+VCR.
	There is an obstacle in the path of the
	remote control and the DVD
	Recorder+VCR.
	The batteries in the remote control are
	dead.

No solution.

Use another disc.

You cannot record the source.

Select the channel on the DVD Recorder+VCR’s built-in TV tuner.

Set clock to correct time. See ‘Set Clock‘ on page 23.

Reprogram Timer. See ‘Timer Recording‘ on page 47.

Reprogram Timer.

No solution.

No solution.

Make A/V connections. Stereo is available only via A/V output from DVD Recorder+VCR.

Select AUX or A/V source as TV input. Set TV audio channel mode to Stereo. See ‘Changing the TV Audio Channel‘ on page 33.

Point the remote control at the remote sensor of the DVD Recorder+VCR.

Operate the remote control within 23 ft (7m).

Remove the obstacle.

Replace the batteries.

Power requirements	200–240V~, 50/60 Hz
Power consumption	32W
Dimensions (approx.)	16.9 x 3.54 x 14.0 inches (430 x 91 x 354 mm) (w x h x d)
Mass (approx.)	13.5 lbs (6.18 kg)
Operating temperature	41°F to 95°F (5°C to 35°C)
Operating humidity	5% to 90%
Signal system	PAL Colour
Recording
Recording formats	DVD Video Recording, DVD-VIDEO
Recordable discs	DVD+R, DVD+RW
Recordable time	[DVD] Approx. 1 hour (HQ mode), 2 hours (SP mode), 4 hours (EP mode),
	6 hours (SLP mode)
Video recording format	[VCR] SP: 3 hours (E-180), LP: 6 hours (E-180)
Sampling frequency	27MHz
Compression format	MPEG 2
Audio recording format
Sampling frequency	48kHz
Compression format	MPEG1 Layer2
VCR Specifications
Head system	4 Head Video, 2 Head Hi-Fi helical scan azimuth system
Timer	24-hour display type
Tape speed	SP: 23.39 mm/sec, LP: 11.70 mm/sec
Tape width	12.7 mm
Rewind time	less than 150 seconds (E-180)
Antenna	75 ohms (VHF/UHF)
Channel coverage	VHF: 2-12, 13-20, 74-80 / UHF: 21-69 / CATV: 1-41
Frequency range	20Hz to 20kHz
Video S/N	Over 43 dB (Standard recording)
Audio S/N	Over 65 dB (Hi-Fi), Over 40 dB (Mono)
Resolution	Over 240 lines (Standard recording)
DVD Specifications

DVD RESET : If the set is in malfunction, press [DVD/VCR] key on the front panel for 4 seconds. As this set is Digital Multimedia Product, malfunction may occurs.

Moisture Condensation

Moisture condensation can occur:	In locations where moisture condensation may occur:
When the DVD Recorder+VCR is moved from a cold	Keep the DVD Recorder+VCR plugged into an AC
place to a warm place.	power outlet with the power on. This will help
	prevent condensation.
Under extremely humid conditions.	When condensation has occurred, wait a few hours
	for the DVD Recorder+VCR to dry before using it.

Laser system	Semiconductor laser, wavelength 650 nm
Frequency response	DVD (PCM 48 kHz): 8 Hz to 22 kHz, CD: 8 Hz to 20 kHz
Video S/N	More than 60 dB
Audio S/N	More than 90 dB
Harmonic distortion	Less than 0.01%
Dynamic range	More than 90 dB
Resolution	Over 500 lines (HQ Recording)
Inputs
Antenna In/Out	U/V-mixed; 75 Ω unbalanced
Video In	1.0 Vp-p, unbalanced
Audio In	-8.8 dBm
DV In	4 pin (i.LINK/IEEE 1394 standard)	DF-8100P/8150P only

REFERENCE

60 61