Identification of Controls
Rear panel
! | @# | $ | ^ |
( * | % | & |
Connectionsti
• There are a variety of ways to connect the DVD Recorder+VCR to your TV and other equipment. Use only one of | INTRODUCTION | |
| ||
the connections described below. Whichever TV connection you use will work with all input sources. |
| |
• Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best |
| |
connections. |
| |
• For better sound reproduction, connect the DVD Recorder+VCR’s AUDIO OUT jacks to the audio in jacks of your |
| |
amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 17. |
| |
Caution | CONNECTIONS | |
• Make sure the DVD Recorder+VCR is connected directly to the TV, and the TV is set to the correct video input. | ||
|
• Do not connect the DVD Recorder+VCR’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.
• Do not connect the DVD Recorder+VCR via your VCR. The DVD image could be distorted by the copy protection system.
Connecting Antenna/Cable
! AC Power Cord | % Scart socket 1 |
Plug into a power outlet. | Connection of a TV set. |
@ AUDIO OUT (L, R) | |
Connect to a TV or other equipment with audio | ^ RF IN (FROM ANT.) |
inputs. | Connect to your antenna or cable TV outlet. |
# COMPONENT/PROGRESSIVE VIDEO OUT (Y Pb Pr) | & RF OUT (TO TV) |
Connect to a TV with Component Video (Y Pb Pr) inputs.
$Scart socket 2
Connection of an additional device (satellite receiver,
Connect to a TV with an RF coaxial input.
*COAXIAL (Digital Audio Out)
Connect to an amplifier with a coaxial digital audio input.
(
Connect to a TV with an S-Video Input.
1Disconnect the antenna/cable from the rear of your TV.
2Connect this cable to the jack marked RF IN (FROM ANT.) on the rear panel of the DVD Recorder+VCR.
Antenna Antenna
Cable TV
Wall Jack
Flat Wire (300ohm)
300/75ohm Adapter | OR | OR |
(Not supplied) |
|
|
Caution
•Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the DVD Recorder+VCR.
Rear of DVD Recorder+VCR
If your cable wire is connected to your TV without a
converter or descrambler box, unscrew the wire from your TV and attach it to the RF IN (FROM ANT.) jack on the rear panel of the DVD Recorder+VCR.
Use the supplied RF cable to connect between the DVD Recorder+VCR’s OUT (TO TV) jack and the antenna input jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels (all cable channels).
14 |
|
|
| 15 |
|
|
