Dansons Group CCGB 1 Choose Mode Of Operation, Decide on mode of operation, Set mode of operation

OPERATING INSTRUCTIONS

IMPORTANT: If at anytime your appliance does not seem to be operating as it had, ALWAYS confirm the mode of operation.

CHOOSE MODE OF OPERATION:

STEP 1 Decide on mode of operation:

Manual Operation Thermostat On/Off or Thermostat Low/High

STEP 2 Find mode of operation:

(For this example we desire the Manual Operation Mode.)

Press and hold in the OFF button, while you are holding in the off button the following cycle will

NOTE: The Starting Point of the	All 4 Lights
cycle, depends on what

mode the control was in.

Feed Rates 1 & 2

Thermostat On / Off Mode

Manual “You are in control”Lights may be difficult To see from an angle.

Feed Rates 1 & 4

All 4 Lights

Only be concerned with the FEED RATE lights. All others do not effect the mode selection process.

All 4 Lights Feed Rates 3 & 4

Thermostat

Low / High Mode

Step 3 Set mode of operation:

To choose the mode you want the board to operate in, simply let go of the OFF button when the proper lights flash.

Then press the START touch pad to activate the setting.

OPERATING IN MANUAL MODE:

TO START

Step 1	Press the START touch pad. It’s that easy!
	The control board goes through the entire start up automatically
	- Convection (heating) fan will start
	(if a speed was selected before)
	- The 300 watt Auto-Igniter will begin to glow and the IGNITER
	LED will be solid.
	- The AUGER CYCLE LED will go solid for 3 seconds, indi-
	cating signal is being sent to the Auger motor.
	- Combustion (exhaust) fan will start and operate at full speed for	60 seconds,
	Then will adjust speed automatically to match the feed rate.

Glow Boy Home & Shop Heater www.glowboystoves.com	23
	23