OPERATING INSTRUCTIONS
TO START … con’t
After Pushing the START touch pad:
The appliance will automatically start in the #1 or low feed rate, no matter where you set it.
When the FEED RATE LED is flashing FAST, this indicates the unit has not reached 120° F exhaust temperature.
When the FEED RATE LED flashes at a SLOWER rate, this indicates the control has reached the 120°F temperature and as entered a 5 minute “Safety Delay”
When the 5 minute “Safety Delay” is complete the IGNITER LED and igniter will turn off and the FEED RATE LED will become solid, meaning you are now in control.
TO ADJUST HEAT
Simply press the START/FEED RATE touch pad to adjust heat output.
Note: During
TO SHUT DOWN
Press the OFF pad.
OPERATING IN THERMOSTAT HIGH / LOW CYCLE (Flashing 3 & 4)
This requires purchasing the optional “Wall Thermostat
This mode of operation is preferred over the ON/OFF mode, during those long and chilly winter nights. The life of the Auto Igniter is greatly increased, and once you have the room to temperature it does not take as much energy to keep it at that temperature.
TO START
Once this mode has been selected, you simply press the START touch pad to | Feed Rates 3 & 4 |
activate the stove. | |
TO ADJUST HEAT |
|
You can now select the HIGH heat output level (2,3 or 4) by pushing the |
|
START / FEED RATE touch pad, you can also select the FAN setting you desire. |
|
When you have selected your high level and fan speeds the LED’s will continue |
|
to flash. The appliance will automatically start at the #1 feed rate until the Start- |
|
up procedure is complete. |
|
The LOW (number 1) or selected High (2,3 or 4) Feed Rate indicator light will |
|
light up depending on if the thermostat is calling for heat or not. When the |
|
desired room temperature is reached the stove will automatically go into the low |
|
heat (#1) cycle. When the temperature in the room drops to the level set at the |
|
thermostat, the stove will again cycle to the HIGH (#2,3 or 4) preselected set- |
|
ting. For optimum heat transfer, the FAN setting should be set at LOW or |
|
MEDIUM. The appliance will run the FAN at HIGH speed when needed, |
|
automatically. |
|
TO SHUT DOWN |
|
To turn off the appliance press the OFF touch pad. |
|
Glow Boy Home & Shop Heater www.glowboystoves.com 2424
