Dayton Installation, Dayton Generator, 2ZRP8, 2ZRP9, Assembly For Wheels And Handles

Dayton Operating Instructions and Parts Manual 2ZRP8, 2ZRP9

Dayton® Generator

generator. Or, use a heavy duty,

Eoutdoor-rated extension cord that is

Nrated (in watts or amps) at least equal G to the sum of the connected appliance L loads. Check that the entire cord is free

Iof cuts or tears and that the plug has

Sall three prongs, especially a grounding H pin.

NEVER try to power the house wiring by plugging the generator into a wall outlet, a practice known as “back feeding”. This is an extremely dangerous practice that presents an electrocution risk to utility workers and neighbors served by the same utility transformer. It also bypasses some of the built-in household circuit protection devices.

If you must connect the generator to the house wiring to power appliances, have a qualified electrician install the appropriate equipment in accordance with local electrical codes. Or, check with your utility company to see if

it can install an appropriate power transfer switch.

For power outages, permanently installed stationary generators are better suited for providing backup power to the home. Even a properly connected portable generator can become overloaded. This may result in overheating or stressing the generator components, possibly leading to a generator failure.

Installation

ASSEMBLY FOR WHEELS AND

HANDLES:

Use the following items for installation: Isolator (3), Bolts (2), Locknut (1), Underbracket Assembly (4), Bolts (5), Washers (6), Collar/Shaft (8), Wheels (9),

Washers (10), Axle Bracket (7), Washers (12), Axle (11), Bolts (13), Handle Assembly (14), Locknut (15).

1.Raise the generator off the work surface to allow clearance to mount the Wheel Kit onto the unit.

NOTE: Make sure the generator is stable and secure before installing the Wheel Kit.

2.Assemble the Isolators (3) to the Underbracket Assembly (4) using two Locknuts (1) and two Bolts (2), tighten bolts securely.

3.Using four Locknuts (1), four Washers (6), and four Bolts (5) assemble the Underbracket Assembly (4) onto the alternator end of the generator. Tighten all bolts securely inside of rail.

4.Fasten the Axle Support Brackets (7) to the engine end of the generator using four Bolts (5), four Washers

(6)and four Locknuts (1). Tighten all bolts securely.

5.Using two Collars (8), six Washers

(10)and Axle (11) mount both Wheels (9) onto the generator.Make sure the axle is centered with the generator.

6.Attach the Handle Assemblies (14 & 15) to the frame using four Bolts (13), eight Washers (12), and four Locknuts (16), tighten bolts.

GROUNDING INSTRUCTIONS

This product must be grounded. If it should malfunction or breakdown,