dCS 954 User Manual | Manual for Standard Software Version 1.5x |
dCS Ltd | June 2000 |
|
|
SDIF/DSD Clk In | BNC |
SDIF/DSD Clk Out | BNC |
This pair of BNC connectors normally take in and give out Word Clock. The functions are set by the menu. Clk In is terminated and Clk Out is regenerated internally, so these lines can be used for daisy chaining many units together, without loading problems. See Figure and Figure for the time alignment of these signals.
Additionally, they can both be set for TTL level AES3 coded signals, using the menu. The input connector is controlled by the BNC I menu command – see page 26 – and the output connector is controlled by the BNC O menu command
–see page 27. As an AES output, it will output the signal on the currently selected input (whatever is playing). The input may be just a clock, for locking purposes, or a full AES3 coded input. The choice is controlled by the BNC menu command – see page 27 – and the input is selected by the BNC button (page 12).
Remote In & Out | 9 pin D type male (2 off) |
If the Windows™ Remote software is in use, connecting Remote In to a com port
Connect up Remote ports using a
Mains Supply | 3 pin IEC (CEE22) |
Switched, fused and filtered IEC mains connector.
Additional InformationAs well as connectors, the rear panel displays the following information about the unit, near the mains supply connector:
Mains Voltage | The actual voltage setting supplied. |
Model Number | dCS 954 |
The underside of the unit will have a label on that contains a number such as 954 4B1 6B2 2A1 3A2 12345. This is the serial number, but it also contains vital configuration information. We will need this number (all of it) to give you support over the phone, or to ship you software updates.
Manual part no: DOC136954 iss 2B1 | Page 11 | file 135954ma2b1.pdf available from website |
Contact dCS on + 44 1799 531 999 | email to: more@dcsltd.co.uk |
(inside the UK replace + 44 with 0) | web site: www.dcsltd.co.uk |