DCS RDS-364GL, RDS-364GD, RDS-484GG manual Oven Self Cleaning Mode, Setting the Oven for Self Clean

OVEN SELF CLEANING MODE

Turn on the ventilator hood above the range and leave it on until after the oven has completed the self-clean cycle.

SETTING THE OVEN FOR SELF CLEAN

1)Push the “CLEAN” Selector Button.

2)Set Oven Control Knob to “CLEAN”. Cooling Blower turns on,

OVEN ON light and HEATING light turn on, LOCK light turns on,

The door closing process takes approximately 60 seconds to complete, at which time the door becomes locked.

AT THE END OF THE CLEAN CYCLE:

The clean cycle takes 5 hours to complete. The OVEN ON light turns off once the cycle has finished.

1)Push the OFF selector button. The door latch will open automatically after the oven temperature falls below 550ºF and the automatic door lock completes its

60 sec. cycle to the OPEN position.

2)Turn the oven control knob to OFF. Wipe white ash with a damp cloth or sponge (after oven has cooled)

before placing oven racks. Fig. 13

3)Replace the oven rack slide assemblies by:

A)Guiding the rear of the rack slide assembly into the bottom rear bracket of the oven side,

B)Guide the top rear of the rack slide assembly into the top U-shaped bracket of the oven side,

C)Lift up the Push Rod so that it rests on the “ledge” of the side support of the assembly, and

D)Screw the assembly secure to the oven through the hole in the front middle section of the side support. Repeat for the other side of the oven.

4)Replace the oven racks.

CAUTION:

The interior of the oven will still be at baking temperatures when the lock light turns off and the oven door can be opened. Use caution as the oven may be hot enough to cause burns.

25