DCS RDS-366, RDS-364GD, RDS-484GG manual Oven Self Cleaning Modes, Oven Door Lock During Self-Clean

OVEN SELF CLEANING MODES

OVEN DOOR LOCK DURING

SELF-CLEAN

When the clean cycle starts, the lock light turns on, and the automatic door lock cycle begins. Do Not attempt to open the door when the lock light is on. You can stop the cycle by pushing the off button. The lock light will turn off only after the oven has cooled below 550ºF, and the automatic door lock has completed its cycle to the open position.

BEFORE SELF-CLEANING THE OVEN:

Remove all utensils and racks

Clean the oven front frame and outer door edges. Wipe up large spillovers and grease. (see fig. 11)

Be sure the light bulbs and glass covers are in place.

Turn on the ventilator hood above the range and leave it on until after the oven has completed the self-clean cycle.

Remove Oven Racks and Rack Slide Assemblies.

Oven front

frame

Outer door

edge

Fig. 11

Fig. 12

NOTE: An Interlock System has been designed so that the Self-Clean

Cycle will not engage until the Rack Slide Assemblies have been removed. The roller assisted rack supports are designed to withstand the temperature range of the standard baking thermostat. They will not withstand the extreme temperatures of pyrolytic self cleaning. To remove the Assemblies:

A)For each side, Remove the retaining screw,

B)Lift up slightly and pull the entire Assembly out. Set aside. Replace the assemblies and retaining screws after the Self-Clean cycle has finished.

27” OVEN RACK SLIDE ASSEMBLY

Wipe out puddles of grease and any loose soil that can be easily removed. Remove any soil that is outside the door seal area. This appliance is designed to clean the oven interior and that portion of the door that is inside the oven. The outer edges of the door and the oven cavity are not in the cleaning zone. Wipe this area clean before setting the oven to self-clean.

24