Dell 3.7.0 manual Clearing Dell Hardware Logs On Linux Operating System

sbin/dellsysteminfo' from a terminal shell prompt to create a report file

•If you selected the DSET option, then the following message is displayed: The DSET installation completed successfully. Enter '/usr/sbin/dellsysteminfo' from a terminal shell prompt to create a report file.

•If you selected the Remote Provider option, the following message is displayed: Remote Provider installation completed successfully.

DSET application is installed at the /opt/dell location by default.

Permanently Installing DSET Application Silently On Linux Operating System

For silent installation, run the command:

dell-dset-lx(bit)-(Version Number).bin -qi <full/collector/provider>

NOTE:

•Case 1: On Linux Operating System, if no CIMOMs (SFCB / Tog-Pegasus) are present and DSET installer is executed in silent mode. DSET Installer installs SFCB and register provider on the system as part of Provider Installation, but SFCB services are not started.

•Case 2: On Linux Operating System if any CIMOMs (SFCB / Tog-Pegasus) is present and services are disabled and DSET installer is executed in silent mode, then

–If Tog-Pegasus is only present and its services are not running. Then the DSET Installer installs SFCB and register provider on the system as part of installation, but its services are not started.

–If SFCB is present and its services are not running, then DSET Installer registers provider under SFCB as part of installation, but its services are not started.

In both the cases, to collect the DSET report user must start the SFCB services and SFCB to be added as part of default start-up services. Also CIMOM Validation check for pre-existing CIMOM cannot be done in silent installation mode.

Clearing Dell Hardware Logs On Linux Operating System

DSET application clears Dell hardware logs (Embedded System Manager logs) from the system without permanently installing the application.

To clear hardware logs from the system:

NOTE: You must be logged in as a root to run the DSET application.

1.At the linux shell prompt, run the ./dell-dset-lx(bit)-(Version Number).bin file. The License Agreement is displayed along with the following message:

Do you agree to the above license terms? ('y' for yes 'Enter' to exit):

2.Enter y.

The installation types are displayed.

3.Enter <option number> to select Clear Dell Hardware Logs option. The following messages are displayed:

*Going to clear the ESM Logs now Do you want to continue? Y/N:

4.Enter y to clear the logs. The following messages are displayed:

22